1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Cap with choke question
Shaleradio
Junior Member
**
Posts: 46
Threads: 15
Joined: Nov 2017
City: Pittsburgh, PA
#1

09-02-2018, 02:16 PM
My next project is a 41-220c.  I have a few questions but my first is regarding the capacitor which I have pictured.  It's listed as #9 and is a .25 mfd with choke.  The choke is chassis ground.  There's is a lot of rubber coated wire in this one and the choke is as well.  Both need replaced but how do I go about this?  I see no resistance listed for the choke even though it is wound around the cap several times.  Can anyone advise me on how to couple a new choke properly with a new cap and if I should order a cap with the same .25mfd designation?
Thanks,
Mark


Attached Files Image(s)
       
Find
« Next Oldest | Next Newest »


Messages In This Thread
Cap with choke question - by Shaleradio - 09-02-2018, 02:16 PM
RE: Cap with choke question - by Phlogiston - 09-02-2018, 02:24 PM
RE: Cap with choke question - by Shaleradio - 09-02-2018, 08:07 PM
RE: Cap with choke question - by Phlogiston - 09-02-2018, 09:59 PM
RE: Cap with choke question - by Shaleradio - 09-03-2018, 03:45 PM
RE: Cap with choke question - by amptramp - 09-08-2018, 09:18 PM
RE: Cap with choke question - by Shaleradio - 09-11-2018, 06:18 PM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration