02-06-2019, 11:13 AM
I have a Westinghouse WR-184 the print is here
http://www.nostalgiaair.org/pagesbymodel...024260.pdf
Getting ready to start the recap and my question is the cap across the incoming line (safety cap) on the print shows no value the actual cap in place is .1 @400v. Seems the value .1 seems is high to me, what do you all think? Use to seeing .01, .05. Not sure if this cap is original could go either way.
Thanks Eric
http://www.nostalgiaair.org/pagesbymodel...024260.pdf
Getting ready to start the recap and my question is the cap across the incoming line (safety cap) on the print shows no value the actual cap in place is .1 @400v. Seems the value .1 seems is high to me, what do you all think? Use to seeing .01, .05. Not sure if this cap is original could go either way.
Thanks Eric
