10-25-2019, 07:00 PM
The last one that I used was Advanced Plating - not an endorsement but they did a good job on the last chassis in reasonable time and at reasonable(?) cost. They are in Nashville. 800-588-6686.
Radios don't seem to be a problem for them, but, if you know that you have a zinc or aluminum part it is better to work that out in advance rather than trusting that they will take special precautions on their own. One plater did the cans just fine but burned off the little 1/4' studs that hold them on (brass).
Radios don't seem to be a problem for them, but, if you know that you have a zinc or aluminum part it is better to work that out in advance rather than trusting that they will take special precautions on their own. One plater did the cans just fine but burned off the little 1/4' studs that hold them on (brass).
