[FStephenMasek]

It sounds nice, and picks up many stations very well! I started by refinishing the cabinet, along with several other wood table radios. It came out very nice. However, the chassis was not easy, as it was full of hard and crumbing old rubber wire insulation, the oscillator coil was bad (it took a while to find that) and the speaker was buzzing. I bought a parts set to obtain the speaker and to check my rewiring. One IF can also had a trimmer capacitor which was not acting right, so I also changed it.

I have approximately $85 in it - $15 for the original, $25 for the parts radio, and $45 for parts and supplies.

I still need to do a better job cleeaning and polishing the knobs - the photos really show that!

I do not know why the photos are cut off, as they show up fine on another forum. You can also go to my Photobucket account (FStephenMasek) to see them.

[Image: http://i269.photobucket.com/albums/jj77/...e006-5.jpg]

[Image: http://i269.photobucket.com/albums/jj77/...ure014.jpg]

[Image: http://i269.photobucket.com/albums/jj77/...e008-7.jpg]

[Image: http://i269.photobucket.com/albums/jj77/...e001-9.jpg]

[Image: http://i269.photobucket.com/albums/jj77/...ure002.jpg]