1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 71 Wire Wound Question
Phil27
Junior Member
**
Posts: 44
Threads: 14
Joined: Dec 2020
City: Kingston State, Province, Country: Ontario
#1

06-12-2022, 02:51 PM
http://www.nostalgiaair.org/PagesByModel...029646.pdf

I am working on a Philco 71 and I would like to replace the first portion of Part #52, a 245 - 185 ohm wire wound resistor. The 185 portion is fine but I get no readings for the 245 portion. Can I substitute a 250 ohm 1 watt resistor in place for the 245 portion of the resistor.
Also since this part appears to be not functioning properly, would it effect the DC readings I was getting? My AC readings were right on.
I would appreciate any thoughts or suggestions.


Attached Files Image(s)
   
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 71 Wire Wound Question - by Phil27 - 06-12-2022, 02:51 PM
RE: Philco 71 Wire Wound Question - by bobclausen - 06-13-2022, 07:51 PM
RE: Philco 71 Wire Wound Question - by MrFixr55 - 06-13-2022, 07:56 PM
RE: Philco 71 Wire Wound Question - by Phil27 - 06-13-2022, 09:22 PM
RE: Philco 71 Wire Wound Question - by MrFixr55 - 06-13-2022, 10:15 PM
RE: Philco 71 Wire Wound Question - by radiohenry - 06-14-2022, 06:17 PM
RE: Philco 71 Wire Wound Question - by radiohenry - 06-14-2022, 06:24 PM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration