09-11-2023, 03:04 PM
Thanks Chas!
I do have access to each end of the winding, but no continuity. After I unwind it, I can check the resistance, of the pieces, hopefully not many, and also hoping I don't lose count of the number of windings.
The caliper I have is pretty accurate, and I also have a table that shows the wire diameter with AND without the enamel coating. I have been getting my magnet wire from Remington Industries. Quick delivery and no shipping fees!
How do you attach the PETE prior to dipping in the beeswax? Would a smooth adhesive tape work?
I have to get some beeswax.
I was hoping to do the unwind and rewind all about the same time, but it sounds like I need to go slower with this and unwind to determine the correct wire, order it and then apply the Liner, dip and rewind.
A wealth of knowledge Chas!
I do have access to each end of the winding, but no continuity. After I unwind it, I can check the resistance, of the pieces, hopefully not many, and also hoping I don't lose count of the number of windings.
The caliper I have is pretty accurate, and I also have a table that shows the wire diameter with AND without the enamel coating. I have been getting my magnet wire from Remington Industries. Quick delivery and no shipping fees!
How do you attach the PETE prior to dipping in the beeswax? Would a smooth adhesive tape work?
I have to get some beeswax.
I was hoping to do the unwind and rewind all about the same time, but it sounds like I need to go slower with this and unwind to determine the correct wire, order it and then apply the Liner, dip and rewind.
A wealth of knowledge Chas!
Thanks
John N3MUN
