10-27-2023, 09:55 AM
Best guess is that the fish paper is stuck to the inside of the can and inside edge of the fish paper has curled under the trimmers. If you have something like long feeler gauge, there's not much room between the paper and coil spacers so it need to be thin you can take it and slip it between the can and paper to free it up. Paper and coils should come out together. If it really stuck fast I'd unsolder the grid cap and shrink tube the wire. Clean the top and put it back together.
GL
GL
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
