|
What model is this Philco Transitone?
05-30-2006, 12:19 PM
 Well, having recapped the entire radio, replaced three of the five tubes (the other two glowed a little so I figured they were still good) and replaced some of the wiring, all I get now is a constant low hum that is unaffected by turning either the volume or dial controls. I suspect that some of the resistors need replacement, but I don't see much written about replacing the resistors in vintage radios. What would be the symptoms of a radio with bad resistors?
« Next Oldest | Next Newest »
Messages In This Thread
What model is this Philco Transitone? - by kstesney - 05-10-2006, 01:45 PM
[No subject] - by Chuck Schwark - 05-10-2006, 02:58 PM
Philco transitone model - by kstesney - 05-10-2006, 03:35 PM
[No subject] - by Chuck Schwark - 05-10-2006, 07:37 PM
Philco model pictures for identification - by kstesney - 05-11-2006, 05:29 AM
[No subject] - by Chuck Schwark - 05-11-2006, 07:53 AM
[No subject] - by Tim Tress - 05-11-2006, 10:08 AM
[No subject] - by Chuck Schwark - 05-11-2006, 11:16 AM
Some identifying numbers - by kstesney - 05-11-2006, 05:11 PM
[No subject] - by Chuck Schwark - 05-11-2006, 06:04 PM
Philco radio identified - by kstesney - 05-12-2006, 08:56 AM
Oh-oh! Rookie mistake. - by kstesney - 05-17-2006, 11:58 AM
[No subject] - by Chuck Schwark - 05-17-2006, 02:17 PM
I'll be a monkey's uncle! - by kstesney - 05-18-2006, 02:47 PM
[No subject] - by Tim Tress - 05-18-2006, 05:35 PM
[No subject] - by kstesney - 05-30-2006, 12:19 PM
Users browsing this thread: 2 Guest(s) |
