04-13-2012, 06:56 AM
I just emptied the bakelite caps in my chassis (5 of them) and when I went to the Riders docs I noticed that the pictorial of the chassis layout does not include two of them (they are in the RF deck, middle of the chassis), both .05 caps. The layout does show the .05 caps, but as paper caps. I haven't had time to check the wiring on the schematic yet.
Does this difference indicate that I may not have the correct schematic for this run? I can't tell what run this chassis is from the chassis markings however. I like to use the parts layout diagram to help positively id the resistors along with color marking when checking tolerance and replacing, so I do use the layout a lot when restoring along with the schematic. Thanks for helping me understand this better.
Steve
Does this difference indicate that I may not have the correct schematic for this run? I can't tell what run this chassis is from the chassis markings however. I like to use the parts layout diagram to help positively id the resistors along with color marking when checking tolerance and replacing, so I do use the layout a lot when restoring along with the schematic. Thanks for helping me understand this better.
Steve
