Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Getting a Philco 70 tomorrow
#1

I am supposed to pick one of these up tomorrow. After looking at the schematic to get ready for a restore, I noticed a "BC" resistor. Is this a wire wound or a candhom type? Just curious as to what I am in for on replacement parts.

Also, where are the serial numbers located so you know if it is an non AVC model or not. This one has copper E-caps from the picture I saw today. I think that makes it an early one from what I have seen in photos online.

The cabinet looks good except for some veneer missing on the grill.

Thanks,
Steve


Messages In This Thread
Getting a Philco 70 tomorrow - by SteveJB - 01-15-2013, 10:20 PM
RE: Getting a Philco 70 tomorrow - by TA Forbes - 01-15-2013, 10:23 PM
RE: Getting a Philco 70 tomorrow - by Ron Ramirez - 01-16-2013, 05:28 AM
RE: Getting a Philco 70 tomorrow - by TA Forbes - 01-16-2013, 02:04 PM
RE: Getting a Philco 70 tomorrow - by SteveJB - 01-17-2013, 07:24 PM
RE: Getting a Philco 70 tomorrow - by Arran - 01-17-2013, 07:49 PM
RE: Getting a Philco 70 tomorrow - by SteveJB - 01-18-2013, 07:57 PM
RE: Getting a Philco 70 tomorrow - by Steve Davis - 01-18-2013, 09:07 PM



Users browsing this thread: