1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Adjusting the 66 compensators
Jim Dutridge
Senior Member
****
Posts: 251
Threads: 45
Joined: Mar 2007
City: Toledo State, Province, Country: OH
#1

07-08-2013, 03:00 PM
These take a 1/4 " hex to adjust but all I have is a metal driver. How much will this affect the alignment? I'm guessing I will have to go to either side of the peak then pull out the driver to see if they are actually peaked.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Adjusting the 66 compensators - by Jim Dutridge - 07-08-2013, 03:00 PM
RE: Adjusting the 66 compensators - by klondike98 - 07-08-2013, 04:22 PM
RE: Adjusting the 66 compensators - by klondike98 - 07-10-2013, 06:04 PM
RE: Adjusting the 66 compensators - by Arran - 08-16-2013, 06:46 PM
RE: Adjusting the 66 compensators - by klondike98 - 08-18-2013, 06:58 PM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration