|
Model 18 (124) Electrolytic Voltage
07-20-2013, 03:25 PM
I have been rebuilding a model 18 (code124) and I restuffed the old E-Cap cans. I recently discovered that the 10uF connected between chassis and B- (part of #59 on the schematic) is 50 volts. I used a 500 volt cap. The radio plays good but I am wondering if I need to change it back to somewhere between 50 and 100 volts.
« Next Oldest | Next Newest »
Messages In This Thread
Model 18 (124) Electrolytic Voltage - by Pappy B - 07-20-2013, 03:25 PM
RE: Model 18 (124) Electrolytic Voltage - by jerryhawthorne - 07-20-2013, 04:17 PM
RE: Model 18 (124) Electrolytic Voltage - by Jim Dutridge - 07-20-2013, 05:38 PM
RE: Model 18 (124) Electrolytic Voltage - by Pappy B - 07-21-2013, 12:10 PM
RE: Model 18 (124) Electrolytic Voltage - by raydog - 07-21-2013, 03:26 PM
RE: Model 18 (124) Electrolytic Voltage - by morzh - 07-22-2013, 08:30 PM
RE: Model 18 (124) Electrolytic Voltage - by klondike98 - 07-22-2013, 09:07 PM
RE: Model 18 (124) Electrolytic Voltage - by BrendaAnnD - 07-23-2013, 01:21 AM
RE: Model 18 (124) Electrolytic Voltage - by morzh - 07-23-2013, 04:09 PM
RE: Model 18 (124) Electrolytic Voltage - by klondike98 - 07-23-2013, 05:42 PM
Users browsing this thread: 1 Guest(s) |
