10-09-2013, 04:39 AM
Good morning,
That is the SW loop, and is part (2) on the schematic, not part (5) which is the loop loading coil.
One lead of the SW loop connects to terminal 3 of the four-screw terminal board at left of the chassis, as viewed from the rear. The other lead connects to the frame of the tuning condenser. There is a hex head screw on the frame, on the right side (again, as viewed from the rear), for this purpose. If the screw is missing, there should be a hole for an 8-32 machine screw there.
That is the SW loop, and is part (2) on the schematic, not part (5) which is the loop loading coil.
One lead of the SW loop connects to terminal 3 of the four-screw terminal board at left of the chassis, as viewed from the rear. The other lead connects to the frame of the tuning condenser. There is a hex head screw on the frame, on the right side (again, as viewed from the rear), for this purpose. If the screw is missing, there should be a hole for an 8-32 machine screw there.
--
Ron Ramirez
Ferdinand IN
