|
Philco 50-1430
11-30-2013, 12:35 AM
The two different runs indicate power supply differences. You need to verify which run the set is. As for the CRT, if you have a tester and the tube shows low emission, let it cook at 8 to 10 volts for a while. Then again, you may not have high voltage. Either of these can cause a dark screen. Recap and then go from there.
« Next Oldest | Next Newest »
Messages In This Thread
Philco 50-1430 - by AJboy123 - 11-24-2013, 06:26 PM
RE: Philco 50-1430 - by ipwizard - 11-25-2013, 05:25 PM
RE: Philco 50-1430 - by AJboy123 - 11-25-2013, 06:50 PM
RE: Philco 50-1430 - by ipwizard - 11-25-2013, 09:35 PM
RE: Philco 50-1430 - by Bob Andersen - 11-26-2013, 02:40 PM
RE: Philco 50-1430 - by AJboy123 - 11-26-2013, 07:13 PM
RE: Philco 50-1430 - by ipwizard - 11-27-2013, 09:42 PM
RE: Philco 50-1430 - by AJboy123 - 11-29-2013, 08:27 PM
RE: Philco 50-1430 - by Bob Andersen - 11-29-2013, 10:07 PM
RE: Philco 50-1430 - by AJboy123 - 11-30-2013, 12:11 AM
RE: Philco 50-1430 - by Big Dave - 11-30-2013, 12:35 AM
RE: Philco 50-1430 - by AJboy123 - 12-08-2013, 07:21 PM
RE: Philco 50-1430 - by Big Dave - 12-08-2013, 10:23 PM
Users browsing this thread: 1 Guest(s) |
