|
Philco Predicta Tandem--correct way to repair on switch?
11-29-2013, 11:09 PM
I would not be above modifying the control to use a different type of switch like a pull on or a rotary rather then the push on, push off type if a replacement could not be found. I would not put a lamp switch in the cord, at least not one of the small ones with a thumb wheel, those are for low current uses like an ornamental lamp.
Regards Arran
« Next Oldest | Next Newest »
Messages In This Thread
Philco Predicta Tandem--correct way to repair on switch? - by berta12 - 11-25-2013, 05:36 PM
RE: Philco Predicta Tandem--correct way to repair on switch? - by Bob Andersen - 11-26-2013, 07:13 PM
RE: Philco Predicta Tandem--correct way to repair on switch? - by berta12 - 11-26-2013, 09:16 PM
RE: Philco Predicta Tandem--correct way to repair on switch? - by Bob Andersen - 11-26-2013, 09:45 PM
RE: Philco Predicta Tandem--correct way to repair on switch? - by berta12 - 11-27-2013, 10:49 AM
RE: Philco Predicta Tandem--correct way to repair on switch? - by Bob Andersen - 11-28-2013, 01:06 AM
RE: Philco Predicta Tandem--correct way to repair on switch? - by Arran - 11-29-2013, 11:09 PM
Users browsing this thread: 1 Guest(s) |
