Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Tom Thumb Portable
#1

Just found this radio locally, it seems to be all original and in good shape. Anyone know about these radios or have one. Pictures to follow.
#2

Is it by Automatic Radio Co?

Paul

Tubetalk1
#3

Have had a few over the years. Yours looks to be in good shape, some the cases warp and are hard to close. They do have a bunch very high value 1/2 resistors (1 meg +) that may be problematic. The loop antenna is part of the front door and is connected though the hinges. I think it uses a 67 1/2 and a 7 1/2v batter for the filaments.. Continental (Admiral) made some versions similar to this set. It an  A.T.T.P. model. Sam's has the info, Riders and Beitman don't.

Terry
#4

Yes is is made by Automatic Radio, 
#5

[Image: http://i1281.photobucket.com/albums/a508...8rlixy.jpg] here are a few pictures, looks like I'm missing the dial pointer.[Image: http://i1281.photobucket.com/albums/a508...lfuusy.jpg][Image: http://i1281.photobucket.com/albums/a508...tlxuei.jpg]




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 5060 online users. [Complete List]
» 2 Member(s) | 5058 Guest(s)
AvatarAvatar

>