Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

80B with brass bezel?
#1

Here's a closeup of the dial on my 80B:
   
You'll notice that the bezel is brass, instead of the usual bakelite variety marked "PHILCO JR."  It looks like the one used on models 51, 52 and a few others.  Every Junior I've ever seen has the bakelite bezel.  So how do you suppose it got here?  Little-known variant, factory error, or swapped by a repairman?
#2

 It may be original, the early Philco model 60s came with a brass escutcheon, those were from 1933, so a model 80 having one isn't really improbable. Philco was known for using up leftover parts or using whatever they happened to have on hand when they transitioned from old to new models or between production runs.
Regards
Arran
#3

It is possible for the reasons Arran mentioned. However I remain skeptical on this particular one. Notice how the speaker screws have been overtightened to the point that the screw heads have been pulled into the veneer? Someone's had their ham-handed mitts on this poor thing, and did it no favors by doing that. The same person could very well have added that 51/52/early 60 and 38 escutcheon to a cabinet that may have had no escutcheon when they acquired it.

--
Ron Ramirez
Ferdinand IN
#4

(02-05-2016, 06:45 PM)Ron Ramirez Wrote:  It is possible for the reasons Arran mentioned. However I remain skeptical on this particular one. Notice how the speaker screws have been overtightened to the point that the screw heads have been pulled into the veneer? Someone's had their ham-handed mitts on this poor thing, and did it no favors by doing that. The same person could very well have added that 51/52/early 60 and 38 escutcheon to a cabinet that may have had no escutcheon when they acquired it.

You think that's ham-handed, you should have seen the way they connected the replacement electrolytics!  Icon_eek  I had one eyeball on the schematic the whole time I was overhauling the chassis.  By the way, it sounds great now, and I implemented a couple of your performance tweaks as well.  Making the cabinet look new again with the damage you saw (and then some) is beyond my woodworking skills, so I took the "do no harm" approach and just cleaned it up and applied Restor-a-Finish.  Here it is:

   
#5

Icon_thumbup  Looks great to me, Paul. Nice job; and the best thing is that you now have it working well as well as looking good. Congratulations, I hope you have many hours of fun listening to it.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 4720 online users. [Complete List]
» 2 Member(s) | 4718 Guest(s)
AvatarAvatar

>