Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Walton Cab lives again.
#1

Here,s a Walton cabinet I recently refinished for a forum member from the other side Icon_eek . I have been refinishing radio cabinets every weekend for quite some time and I should be refinishing a rare Zenith 16a63 stratosphere here over the summer and another rare console. I also will be refinishing some radios and clocks from Decopobia company in Florida. It looks like there are some folks out there that love my refinishing skills. That there will help me later down the road when I retire from Paint and body shop work. I think that between SS and refinishing radio cabinets and some antique furniture that should sustain me and till I kick the bucket.


Attached Files Image(s)
                   
#2

Ya do some really fine work!
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#3

Beautiful Icon_thumbup

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
#4

OH MAN!  Beyond Beautiful! You sure do good work. That someone is going to be very happy! I wish it was me!
#5

Sweet looking. Icon_clap

Paul

Tubetalk1




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently no members online.

>