Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help!! I don’t know the model
#1

Hi there, I just bought this the other day at a resale shop so there was no info about it other than “record player table”. I figured out the brand by myself but cannot for the life of me figure out the model. The turntable needs a new needle so that’s why I need the model, I believe there is another piece missing as well, also on the turntable. Any information would be fantastic, thanks in advance!!


Attached Files Image(s)
                   
#2

Looks like a 60s model. I believe Philco used Voice of Music changers in the consoles. You probably have to take a closer look at the cartridge to match a needle. Quite often the original cartridge has been replaced.
#3

Hi and welcome,
There's a possibility that the radio and the phono where sold as separate units. In this case the model number would be on found on each component.
As for the needle/cartridge I'd give these guys a try: https://thevoiceofmusic.com/catalog/phono_needles.asp  You may be able to send them a pic of what you have and go from there.

GL with w/project!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

That is very nice...  Something I am more familiar with have a similar VM unit my first wife just had to have..
Early American or Colonial design, I never cared for the Spanish or Mediterranean designs...  He, he, the V-M worked right up to the day she hauled it away during the divorce Icon_lol

BTW it was Solid-State, went through at least 6 needles and one ceramic cart. My favorite album was "Switched on Bach" at near full volume, she hated it...

Pliny the younger
“nihil novum nihil varium nihil quod non semel spectasse sufficiat”




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM
Philco 91 Speaker Replacement
I was wondering if I could use a more common Philco speaker and just add the resistance I need for the coil and get a ne...dconant — 07:45 AM

[-]
Who's Online
There are currently 3058 online users. [Complete List]
» 2 Member(s) | 3056 Guest(s)
AvatarAvatar

>