Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Test Equip Allowed?
#1

Not quite a radio, but it is over 62 years old? Have received a Heathkit model TC-1 tube tester.

Meter movement is broken. Takes a 1 ma at 100 mv movement.

Any one know of a serviceable replacement source?

Hole that it fits is 3 inches. 3 5/16 H. x 3 3/4 W. scale viewing area.

If this is not in the right spot please feel free to move to proper location.

Thanks,

Gary
#2

I'm not sure but the last piece of Heath gear I saw with a meter used a Weston made meter. What part of the movement is broken? You could try opening it up and repairing it but it is a delicate job.
Regards
Arran
#3

The set screws that allow the coil movement to pivot are not able to be adjusted.
It appears that the dial side set screw is missing a point on the moving coil to allow it to be set properly in balance between the two set screws.

Thanks for the info, I'm trying to locate a suitable replacement to keep using the test set.




Users browsing this thread:
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5199 online users. [Complete List]
» 1 Member(s) | 5198 Guest(s)
Avatar

>