Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Can Anyone ID this radio?
#16

DeJur Corporation seems to come up a lot with home movie projectors and camera equipment, nothing with radios. In fact it seems that it was once merged with a company called AMSCO, not to be confused with ANSCO, at some point and was called DeJur-AMSCO Corporation. So that would explain the monogram with the letters D.J.A in the center of the dial, it must stand for DeJur-AMSCO.
Regards
Arran
#17

Thanks Arran. I found some info where they also manufactured some kind of three tube amplifier back in 1926. The radio dial has the DJA initials, then the company name is also stamped on it, so I am going to conclude that they manufactured it. They also made radio parts for other companies, so who knows for sure. I was very surprised that it even works. I should have the cabinet finished this weekend. It is currently stripped and looks pretty good.

The artist formerly known as Puhpow! 8)




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5301 online users. [Complete List]
» 2 Member(s) | 5299 Guest(s)
AvatarAvatar

>