Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New (to me) 57C
#1

Sorry, I am coming in late on this thread.  I have a Philco 57C that has been refurbished.  I am attempting to use it at my office.  Is it possible to use a home built antenna inside that will give me some reception?  I can pick up one station without too much effort (holding wire up to the 2 antenna connections).  I am very much a newby with these radios.

Thanks!

Rob
#2

locostbamboo
welcome to the phorum
guess it depends on what kind of office your in old building or new.  on how well it would work 
best to use long wire around or under carpet  with ground wire to water pipe or heater duct.
you can spend few bucks to get am transmitter and use that way you play any thing you like
sam
#3

Not exactly true, but close.  I bought the 57C at an auction years ago and my father knew someone who got it working for me.  It has a newer power cord and I believe had a tube or two replaced.  I am interested in any thoughts on an antenna.  I have it at work and my office is in the middle of a concrete building (old Best Buy).  I had a suggestion on an AM transmitter which sounds very promising.  I would appreciate any advice offered.

Thanks.

Rob in Oregon


Attached Files Image(s)
   
#4

Thank you Mafiamen.  I think the AM transmitter sounds really cool.  I did some research and it looks like I might be able to build one  (I am cheap)!  Icon_smile

I appreciate this and any other advice!

Rob
#5

moved post to keep in one place Icon_thumbup

hi rob
if going with am transmitter  one I use and most here I think use is
  sstran you build it your self comes as  kit but you need to know how to soldier as parts  are small
but worth it  about 100.
then you can use ipod or phone or computer to play what you like




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5304 online users. [Complete List]
» 2 Member(s) | 5302 Guest(s)
AvatarAvatar

>