Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Do you know this part?
#1
Photo 

I began my first-ever restoration -- a 37-610 code 125. And when I removed the chassis from the cabinet, this piece was jammed underneath. It appears to be plastic so I don't think it comes from the radio, but I just don't know. I think it's plastic because it appears to have melted beneath the chassis. I don't think bakelite ever gets misshapen like this, does it? This radio did have signs of having been repaired once in the past. The power cord was replaced with a modern cord. One of the rubber bushings that the chassis sits on inside the cabinet is missing and it appears this piece was jammed in there to keep the chassis from shifting. But all of this is mere speculation. I am a total novice at this. So anyone know what this is? My only concern is that it could come from the radio somehow.

[Image: http://www.jamesdavidporter.com/photo%201.JPG]
[Image: http://www.jamesdavidporter.com/photo%202.JPG]

Thanks!
#2

Hi Jim

No worries. That does not look like any Philco part I have ever seen. I think you're right, it's something someone just stuck in there for some reason.

--
Ron Ramirez
Ferdinand IN
#3

Welcome to the Phorum Jim!  
#4

Was about to say the same, does not belong there, pobably got there by accident.
#5

Dick Tracy left it behind.




Users browsing this thread:
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 4031 online users. [Complete List]
» 2 Member(s) | 4029 Guest(s)
AvatarAvatar

>