Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Fisher X-101-D or Eico ST 70
#1

So I need your opinion on which one should I keep. Both have 7591 output tubes but the Fisher I believe has a built in multiplex, correct me if I'm wrong. I will provide pictures soon, having some issues with photobucket.
#2

pictures i hope ! of the Fisher[Image: http://i1281.photobucket.com/albums/a508...jgzw4j.jpg]
[Image: http://i1281.photobucket.com/albums/a508...wcxbde.jpg]
#3

And pictures of the Eico that i have already finished the rebuild, and it sounds fantastic. So someone tell me will the Fisher perform better.[Image: http://i1281.photobucket.com/albums/a508...lhiqjb.jpg]
[Image: http://i1281.photobucket.com/albums/a508...sqaybd.jpg]
#4

I've had both and I'd keep the Fisher. No multiplex in the Fisher as a MPX is used in a tuner or receiver. The X-101-D does have a strange bias set up but it's a great sounding amplifier.
#5

You'd probably get more $ for the Fisher (if both restored,) but probably not a whole lot of difference otherwise.
#6

Well i tried to sell the Fisher and no takers, so i'm keeping it and selling the Eico. The Eico is restored and the Fisher is not but i will remedy that real soon. Thanks everyone for the input and suggestions.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 5353 online users. [Complete List]
» 1 Member(s) | 5352 Guest(s)
Avatar

>