10-03-2014, 07:31 AM
Mikethedruid,
Thanks Mike,
To answer to you questions, +455 I get throughout the entire range. There is a pattern.The indicated frequencies on the dial are always less than the station frequency but it is worse at the lower end than at the higher.Of course, I can move the pointer, but it will look pretty odd, as the needle will look at 2 o'clock vs 3 (the right side of the dial) and 8 o'clock at the left vs 9. Bending the plates I simply do not know how, as I've never done it before, unless it is gone just by the seat of your pants. Changing the capacity of the J padder after alignment, as I mentioned before, helps to bring the pointer to where it should be but that works only between 600 and 900, then the discrepancy comes in play again,albeit not as pronounced.
Thanks Mike,
To answer to you questions, +455 I get throughout the entire range. There is a pattern.The indicated frequencies on the dial are always less than the station frequency but it is worse at the lower end than at the higher.Of course, I can move the pointer, but it will look pretty odd, as the needle will look at 2 o'clock vs 3 (the right side of the dial) and 8 o'clock at the left vs 9. Bending the plates I simply do not know how, as I've never done it before, unless it is gone just by the seat of your pants. Changing the capacity of the J padder after alignment, as I mentioned before, helps to bring the pointer to where it should be but that works only between 600 and 900, then the discrepancy comes in play again,albeit not as pronounced.
