|
Hunting down the short in a Motorola 61CA
08-20-2015, 06:01 PM
On the 6D6? Pins 3,4, and 5 of the 6D6 are all tied together and to the chassis from pin 5 (it came that way), but pin 3 of the 75 is connected to the sw antenna coil, the 820K ohm resistor and the IF, and that .05 cap that goes to pin 4 of the 6D6 which I guess does ground it to the chassis, right? So you say either remove that cap or ground it to the chassis? Hmmm. Is the cap C20, then?
Charlie in San Antonio
« Next Oldest | Next Newest »
Messages In This Thread
Hunting down the short in a Motorola 61CA - by ccomer1955 - 08-20-2015, 12:03 PM
RE: Hunting down the short in a Motorola 61CA - by ccomer1955 - 08-20-2015, 01:37 PM
RE: Hunting down the short in a Motorola 61CA - by Radioroslyn - 08-20-2015, 05:22 PM
RE: Hunting down the short in a Motorola 61CA - by ccomer1955 - 08-20-2015, 06:01 PM
RE: Hunting down the short in a Motorola 61CA - by Radioroslyn - 08-20-2015, 09:13 PM
RE: Hunting down the short in a Motorola 61CA - by ccomer1955 - 08-20-2015, 10:33 PM
RE: Hunting down the short in a Motorola 61CA - by Steve Davis - 08-20-2015, 11:26 PM
RE: Hunting down the short in a Motorola 61CA - by ccomer1955 - 08-21-2015, 09:57 AM
RE: Hunting down the short in a Motorola 61CA - by Steve Davis - 08-21-2015, 09:36 PM
RE: Hunting down the short in a Motorola 61CA - by ccomer1955 - 08-22-2015, 01:42 PM
RE: Hunting down the short in a Motorola 61CA - by ccomer1955 - 08-22-2015, 07:45 PM
Users browsing this thread: 1 Guest(s) |
