|
What is the correct IF for Philco 80
09-26-2015, 08:21 PM
(09-26-2015, 04:55 PM)klondike98 Wrote: Philco had a special tool for the trimmers. Here's a thread on it and a tool I made. Folks often just warm up the end of of a bic pen and squish it over a nut to form a tool. Niceeee I like the cap screw idea. Thanks T
« Next Oldest | Next Newest »
Messages In This Thread
What is the correct IF for Philco 80 - by bastardbus - 09-26-2015, 02:37 AM
RE: What is the correct IF for Philco 80 - by Radioroslyn - 09-26-2015, 09:01 AM
RE: What is the correct IF for Philco 80 - by bastardbus - 09-26-2015, 02:52 PM
RE: What is the correct IF for Philco 80 - by klondike98 - 09-26-2015, 04:55 PM
RE: What is the correct IF for Philco 80 - by bastardbus - 09-26-2015, 08:21 PM
RE: What is the correct IF for Philco 80 - by bastardbus - 09-29-2015, 08:45 PM
RE: What is the correct IF for Philco 80 - by klondike98 - 09-29-2015, 08:58 PM
RE: What is the correct IF for Philco 80 - by Nathan Slingerland - 09-30-2015, 12:16 AM
RE: What is the correct IF for Philco 80 - by codefox1 - 09-30-2015, 04:03 AM
RE: What is the correct IF for Philco 80 - by bastardbus - 09-30-2015, 10:23 AM
Users browsing this thread: |
