01-20-2016, 09:19 AM
I've been going thru the schematic and if I'm reading it properly I've found 4 resistors and three capacitors have been removed at some point. History of the radio is unknown. I purchased it over ten years ago and had a supposedly radio tech try to get it operational. He replaced the caps and a few resistors then gave up. Since then I 've been dabbling in radio repair and trying to learn as you all know from my horrible posts in the past.(38-116 fix, Philco 70,71)
I counted all the resistors in the chassis then compared to the schematic and come up 4 short...so far I cannot find 3of the 4.... #59 the 2.2.meg, #22 - 1000ohm and #23 - 15,000ohm. I cannot see where they may have once been in the circuit is the other problem. The caps are #8,9,38 (I think).
If those resistors were back in the circuit would that fix my problem or does their placement not affect the low bias, high b+?
Bob
I counted all the resistors in the chassis then compared to the schematic and come up 4 short...so far I cannot find 3of the 4.... #59 the 2.2.meg, #22 - 1000ohm and #23 - 15,000ohm. I cannot see where they may have once been in the circuit is the other problem. The caps are #8,9,38 (I think).
If those resistors were back in the circuit would that fix my problem or does their placement not affect the low bias, high b+?
Bob
