08-01-2016, 11:14 PM
>So as long as it's a 465 kc it should do the job?
Your a little better off if it is a output transformer.The secondary has a low impedance to match the diode load. The input transformer secondary matches the grid of the IF amp tube which is high impedance.
> And something close may be able to be tuned to 465 simply with the padders?
That's why I mentioned the 460 and the 470kc Philco transformers.
GL
Your a little better off if it is a output transformer.The secondary has a low impedance to match the diode load. The input transformer secondary matches the grid of the IF amp tube which is high impedance.
> And something close may be able to be tuned to 465 simply with the padders?
That's why I mentioned the 460 and the 470kc Philco transformers.
GL
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
