speaker replacement

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

speaker replacement

Guest
Unregistered

12-31-2005, 06:50 AM

Thanks for the fast reply guys. I'll be checking Ebay.

« Next Oldest | Next Newest »

Messages In This Thread

speaker replacement - by Guest - 12-28-2005, 07:49 PM

[No subject] - by Ron Ramirez - 12-28-2005, 09:42 PM

[No subject] - by Chuck Schwark - 12-28-2005, 10:14 PM

[No subject] - by Ron Ramirez - 12-29-2005, 12:05 PM

[No subject] - by Guest - 12-31-2005, 06:50 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 38-2 Low Volume
Both sch, the one you showed in the beginning and the one I see on Nostalgia, show 40K for the 2nd audio plate.morzh — 02:25 PM
Model 96 cabinet veneer
I can't figure out what the first step is, let alone the final step. I have tried copying pictures from my hard drive a...TGLager — 01:40 PM
Philco 38-2 Low Volume
I managed to get some more time on this. Hi Mr. FixIT, The radio has been recapped. Many of the resistors were rep...dconant — 01:39 PM
Philco 38-2 Low Volume
Thanks guys for the help. I started looking at these points but I have to quit for the day. I will be looking into this ...dconant — 12:23 PM
RCA WV-98c
Check out this crazy zero pot operation. Touching it drives it crazy. Its rubber tipped. Also the 6al5 has no negative v...daveone23 — 12:08 PM
Philco 38-2 Low Volume
If you check all of that and still have a problem (my first inkling would be one of the 6F6s) then look at the 6J5 phase...RodB — 10:44 AM
RCA WV-98c
Those will probably depend on teh switch combination. Could you list some that you see, their values and what they sh...morzh — 10:26 AM
Model 96 cabinet veneer
You are probably skipping the final step. Once you select the photos you want and they get downloaded, the system assign...RodB — 09:36 AM
RCA WV-98c
At this point, there is no input, just internal voltages Which are incorrect and not sure what they should be.daveone23 — 09:15 AM
Philco 38-2 Low Volume
Hi DConat, Generally, the lower the plate voltage the less negative the grid voltage has to be. Since the plates an...MrFixr55 — 09:27 PM

Who's Online

There are currently 1157 online users. [Complete List]
» 2 Member(s) | 1155 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me