1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Value of caps in block?????
Dan Walker
Senior Member
****
Posts: 363
Threads: 100
Joined: Jul 2011
City: Calgary, AB, CA
#3

11-16-2011, 05:53 PM
Ron I must say that I am sorry but I made a mistake in the numbers of the block... The proper number is 4989Z which[using the info you gave me ] transfers to a number of 4989 odg...If I have this right it means that I can put two caps of .10 in the block and hook them up to the same pins as the old ones.. According to what I see it is #1 to #5 and #2 to #3...[.Pin #1 and #2 are connected and go to ground] WOULD THIS BE CORRECT?
Once again I am sorry for the inconvenience this may have caused you,I will be more carefull with my numbers next time. Thank you Dan
   Living in Calgary Alberta
Find
« Next Oldest | Next Newest »


Messages In This Thread
Value of caps in block????? - by Dan Walker - 11-16-2011, 03:19 PM
Re: Value of caps in block????? - by Ron Ramirez - 11-16-2011, 05:09 PM
Re: Value of caps in block????? - by Dan Walker - 11-16-2011, 05:53 PM
Re: Value of caps in block????? - by Ron Ramirez - 11-16-2011, 07:23 PM
Re: Value of caps in block????? - by Texasrocker - 11-16-2011, 08:39 PM
Re: Value of caps in block????? - by LASJayhawk - 12-08-2011, 09:15 PM
Re: Value of caps in block????? - by Ron Ramirez - 12-09-2011, 05:32 AM
Re: Value of caps in block????? - by DeckApe - 12-11-2011, 11:54 AM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration