|
38-690 Power Supply Chassis Rebuild
05-08-2012, 03:25 PM
I think if the power rating is not very critical, and also considering that many of today's resistors are of smaller sizes than those being replaced, in some cases it may be possible to axially drill through the old dog-bone and put the new one inside.
I should try that sometime.
« Next Oldest | Next Newest »
Messages In This Thread
38-690 Power Supply Chassis Rebuild - by camman - 05-08-2012, 10:10 AM
RE: 38-690 Power Supply Chassis Rebuild - by codefox1 - 05-08-2012, 10:19 AM
RE: 38-690 Power Supply Chassis Rebuild - by 7estatdef - 05-08-2012, 11:53 AM
RE: 38-690 Power Supply Chassis Rebuild - by morzh - 05-08-2012, 12:58 PM
RE: 38-690 Power Supply Chassis Rebuild - by Bob Andersen - 05-08-2012, 03:01 PM
RE: 38-690 Power Supply Chassis Rebuild - by morzh - 05-08-2012, 03:25 PM
RE: 38-690 Power Supply Chassis Rebuild - by camman - 05-08-2012, 04:23 PM
RE: 38-690 Power Supply Chassis Rebuild - by Bob Andersen - 05-08-2012, 04:42 PM
Users browsing this thread: 1 Guest(s) |
