Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need identification
#1

Picked this radio up at an auction. Works very well. Can't find much out. Need a little help. Thanks in advance.


Attached Files Image(s)
               
#2

It looks like a model 50 922
 Here is a link.

https://philcoradio.com/gallery2/1950a/
 Dan in Calgary

   Living in Calgary Alberta
#3

That's it!! Really appreciate your help.
#4

The radio in question is a 51-932. It is identical to 50-922 Dan mentions. For 1951 model year the 51-932 referred to the cabinet. The 932 model only came in maroon. I gleaned this info from the model label on your set, and the information available in the Philco Radio Gallery https://philcoradio.com/gallery2/1951a/

Hope this helps. Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#5

Some info from beitmans          
#6

Or    Part11-Philco Home Radio Yearbook 1951-final.pdf (philcoradio.com)
The code 121 chassis used the octal rectifier vs the code 122 using a loctal. GL and it looks like it's a pretty nice set w/a rf amp and
osc tracking adj @the hi & lo ends of the band.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2302 online users. [Complete List]
» 3 Member(s) | 2299 Guest(s)
AvatarAvatarAvatar

>