1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 15DX restoration tips?
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#2

05-26-2009, 08:44 PM
Hi

Congratulations on your acquisition! That is certainly one of Philco's nicer offerings.

The veneer was walnut; I looked your cabinet up and the 15DX page in my copy of Philco Furniture History is almost unreadable. However, I could make out that the top is 1/4 sliced American Black Walnut, with butt walnut on the instrument panel.

Not sure what to recommend on the molding. I think I would try to find a competent woodworker who could replicate molding using any pieces that remain as a template.

As for the speakers. There are several sources for speaker reconing. Some other folks may chime in with their favorites. A couple are listed on my site's Resources page.

http://www.philcoradio.com/resourceb.htm
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 15DX restoration tips? - by Bob Andersen - 05-22-2009, 10:36 PM
RE: Philco 15DX restoration tips? - by TA Forbes - 04-26-2012, 12:57 PM
RE: Philco 15DX restoration tips? - by TA Forbes - 04-27-2012, 11:38 AM
RE: Philco 15DX restoration tips? - by Arran - 05-05-2012, 12:07 AM
Re: Philco 15DX restoration tips? - by Ron Ramirez - 05-26-2009, 08:44 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2294 online users. [Complete List]
» 4 Member(s) | 2290 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration