Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

model 76 or 77
#1

Hi guy's,
Anyone know of a good way to distinguish the difference between a model 76 and a model 77 chassis?
Thanks
#2

The 76 has a local-distance switch (two position) on the right (when looking at the chassis from its front), with the volume control on the left.

The 77 has a four-point tone control on the left, with the volume control on the right.

The 76 uses a large speaker socket with the four pins spread far apart.

The 77 uses a smaller speaker socket with the pins closer together, much like a 4-pin tube socket except it has three large pins and one small pin.

Both use 7 tubes.

--
Ron Ramirez
Ferdinand IN
#3

Hey,thank Ron for the speedy reply.
Now I know.
Any idea why I would get a little motor boating when I crank up the volume?
This has not been re-capped yet, but seems to work pretty good considering.
Have a great day.
#4

murf Wrote:Any idea why I would get a little motor boating when I crank up the volume?
This has not been re-capped yet,

There's your answer. Icon_smile

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3882 online users. [Complete List]
» 1 Member(s) | 3881 Guest(s)
Avatar

>