Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Diference between 45F and 45L
#1

Hi All;
Since my Philco 45 is a chassis Only..
Can anyone tell me What is the Difference between the Philco 45F and the Philco 45L ??
I know mine was not origionally a Philco 45C, as the Speaker is Not mounted on the Chassis.. My Speaker is 7.5 inches edge to edge and a 6.0 inch cone.. It looks like it was reconed, and it has only one small partial hole, probably from a small bolt..
THANK YOU Marty
#2

See http://www.philcoradio.com/assets/setindex.pdf
45F is a console model
45L is a lowboy model
#3

Hi All;
Wow, I've never seen this list..
Now I have to figure what is the difference between the Console and a lowboy.. I'll just have to look at some pictures..
THANK YOU Marty
#4

See Ron's photo gallery:
http://www.philcoradio.com/gallery/1935a.htm#v
and
http://www.philcoradio.com/gallery/1935c.htm#i
#5

Hi All;
Does Anyone have a picture of a Philco 45F Console, so I can see the Difference between an F and an L ??
THANK YOU Marty
#6

Marty, see my post just above yours.
#7

Hi All;
Thank You Klondike, You were posting Your Links at about the same Time I was asking the Question..
So, a Console is basically a LowBoy withOut Legs, Right ??
THANK YOU Marty




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 5355 online users. [Complete List]
» 1 Member(s) | 5354 Guest(s)
Avatar

>